C-SCOPE R1 Instructions d'exploitation télécharger pdf (Page 9)

LEARN ACCEPT

DISCRIM SET

SENSITIVITY LEARN REJ

AUDIO LEARN ACC

PROGRAMS EDIT

SET UP BACK DONE

Learn Accept allows you to ‘teach’ the R1 to accept one or more targets that are swept over

the search head. Once Learn Accept is selected the sample or samples are swept several

times over the head. The R1 will then clear the disc setting at the sample ID point so that

any objects with the same ID as the sample will be accepted. Care should be taken to

ensure that you do not ‘Learn Accept’ ground, ID 0.

TIP!

This can be used as a Notch Accept or Token hunting facility. First use Discrim Set to

ignore all signals. Then use Learn Accept to clear the specific ID points of the objects to be

found.

EDIT

DISCRIM SET

SENSITIVITY LEARN REJ

AUDIO LEARN ACC

PROGRAMS EDIT

SET UP BACK DONE

This function enables you to set or reset the Discrimination at any desired point within the

entire range. Once selected a flashing block, (cursor), will appear under the 0 at the left

hand edge of the display. Pressing the ENTER button will toggle the block at the current

cursor position between ACCEPT and REJECT. Rotating the MENU/SCROLL control will

move the cursor. Rotate the control to the desired ID position and press the ENTER key to

either set (REJECT) or clear (ACCEPT) the block.

When you have finished rotate the

MENU/SCROLL control clockwise until DONE is highlighted in the lower right hand

corner of the display, then press ENTER.

SENSITIVITY

DISCRIM MOTION GAIN

SENSITIVITY PIN -PT GAIN

AUDIO TUNE

PROGRAMS

SET UP BACK

These functions set the sensitivity of the R1 to signals.

MOTION GAIN

DISCRIM MOTION GAIN

SENSITIVITY PIN -PT GAIN

AUDIO TUNE

PROGRAMS

SET UP BACK

This sets the sensitivity of the audio signal and the ID display in normal search or MOTION

mode. The level is set by rotating the MENU/SCROLL control, the current level is indicated

by the bargraph and number on the display. Once the desired level has been set by rotating

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Commentaires sur ces manuels

Pas de commentaire

C-SCOPE R1 Instructions d'exploitation Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle C-SCOPE R1