C-SCOPE R1 Guide d'installation télécharger pdf (Page 10)

Introduction4

2.5

Installation instructions

IMPORTANT

Do not connect your PicoScope 4000 Series scope device to the PC before you

have installed the Pico Technology software.

If you do, Windows might not recognise the scope device correctly.

Procedure

Follow the instructions in the Installation Guide included with your product package.

Connect your PC Oscilloscope to the PC using the USB cable supplied.

Checking the installation

Once you have installed the software and connected the PC Oscilloscope to the PC,

start the PicoScope software. PicoScope should now display any signal connected to

the scope inputs. If a probe is connected to your oscilloscope, you should see a small

50or 60 hertz signal in the oscilloscope window when you touch the probe tip with

your finger.

Moving your PicoScope PC Oscilloscope to another USB port

Windows XP SP3

When you first installed the PicoScope 4000 Series PC Oscilloscope by plugging it into

a USB port, Windows associated the Pico driver with that port. If you later move the

oscilloscope to a different USB port, Windows will display the "New Hardware Found

Wizard" again. When this occurs, just click "Next" in the wizard to repeat the

installation. If Windows gives a warning about Windows Logo Testing, click "Continue

Anyway". As all the software you need is already installed on your computer, there is

no need to insert the Pico Software CD again.

Windows Vista, 7 and 8

The process is automatic. When you move the device from one port to another,

Windows displays an "Installing device driver software" message and then a

"PicoScope 4000 Series PC Oscilloscope" message. The PC Oscilloscope is then ready

for use.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 105 106

Pas de commentaire

C-SCOPE R1 Guide d'installation Page 10