C-SCOPE XD Manuel d'instructions télécharger pdf (Page 29)

Non-Metallic Pipe Tracing: Sonde

The Sonde is powered by a single AA (LR6) size alkaline battery.

1. To turn the Sonde on, separate the two halves of the Sonde casing. Insert

new battery into the battery compartment with the positive end down.

2. Screw the two halves of the Sonde together being careful not to over

tighten them. The Sonde is now transmitting a signal.

3. To turn the sonde off the battery must be removed.

Pinpointing

Before inserting the Sonde into the pipe itself it is best to set up the locator such that the Sensitivity is already correctly

adjusted to suit the pipe depth.

1. The blade of the locator must be held IN LINE with the Sonde at

all times.

2. Turn the locator to Generator mode and switch on. Check the

battery level indicator to confirm the locator batteries are usable. Replace if necessary.

NOTE This is easier to do when the Sonde is visible at the bottom of the manhole rather than already in the pipe.

NOTE This is the opposite orientation to the way in which the locator is held for most other locating tasks.

+ -

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 40 41

Pas de commentaire

C-SCOPE XD Manuel d'instructions Page 29